EFR14 Direct Injection Driver Module, max 12 Cylinders

• Aircraft grade aluminum enclosure with 2 motorsport connectors
• PowerPC microprocessor
• 12 cylinder fully sequential direct injection drivers
• 2 drivers for high pressure DI fuel pumps
• Programmable injector currents for boost and hold stages
• Programmable boost voltage
• Programmable fuel pump currents for hold stages
• Programmable timers in current profiles

• 12 digital inputs for DI injector command
• 2 digital inputs for DI high pressure fuel pump command
• 6 analog sensor inputs (0-5V)

• 12 pairs of low and high side drivers for DI fuel injectors
• 2 pairs of low and high side drivers for DI high pressure fuel pumps
• 3 independent 5.0v sensor power supplies

• 2 CAN 2.0B interfaces

• Dimensions (very small and light)
  • Weight 480g (16 oz.)
  • 187 x 134 x 25mm  (7 1/8" x 5 1/4" x 1")
  • All aluminum and high-end vibration stable SMD PCB
• 2 motorsport connectors with high pin density (74 in total)

• Temperature range -40 to 125 Celsius (-40 to 257 Fahrenheit)
• Power supply 7-16v
• Splash-proof

These parts are legal for sale and use on uncontrolled (Non-Emissions Controlled) vehicles and on off-road racing vehicles ONLY.

WARNING: It is against the law to install these parts on an emissions controlled vehicle

All OBR products are exclusively manufactured for racing purposes. Installing these products on any vehicle eliminates the legal use, in any capacity, on public roads/highways and may be subject to fines and/or criminal liability as per the Clean Air Act.